Step 3: Scribe, cut and smooth the bends
Mark the beginning and ceasing purposes of the stretcher bends, then recorder them utilizing the 1/4-in.-thick scribing support. Utilize the same trap to stamp the bend on the legs.
Cinch together the stretchers and legs and cut the bends with a jigsaw. This trap will give you indistinguishable coordinating parts and keep you from needing to check bends more than once.
Notice in Figure B that there's a 1/4-in.- wide brace. That is for scribing the bends on one leg and one stretcher. When you tear the support, pick wood that doesn't have any bunches or it'll snap when you're twisting it. Either get an assistant to help you make the copyists or utilization clasps and nails.
It's basic: Just check your beginning and ceasing focuses, twist the support and make your recorders. Brace both sheets together and make the cuts with a jigsaw. At that point brace both sheets together again and smooth out the bends with a belt sander.
Step 4: Round off corners
Utilize a quarter to blueprint the outside corners, then cut and sand every one of them.
Here's the part about the quarter. Use it to check all the outside corners for adjusting (Photo 5). Additionally follow around the quarter to stamp the closures of the handholds. At that point utilize a 1-gallon paint can to step the front and back of the handhold.
Diminish all the edges with 100-coarseness sandpaper, and on the off chance that you wish, sand all the parts for completion before gathering.
0 komentar:
Posting Komentar